esphome-docs/components/light/spi_led_strip.rst

69 lines
2.4 KiB
ReStructuredText
Raw Normal View History

SPI LED Strip Light
===================
.. seo::
:description: Instructions for setting up SPI LED RGB lights in ESPHome.
:image: ../components/light/images/apa102.jpg
The ``spi_led_strip`` light platform drives one or more SPI interfaced RGB LEDs. These LEDs are often used in strips, where
each LED is individually addressable. This component requires an SPI interface to be configured.
This component has been tested with APA102 LEDs and should also work with HD107 and SK9822 type LEDs, or any others
with a similar interface - SPI, 8 bits per colour and BGR ordering.
.. figure:: images/apa102.jpg
:align: center
:width: 75.0%
.. code-block:: yaml
# Example configuration entry
spi:
mosi_pin: GPIO3
clk_pin: GPIO9
light:
- platform: spi_led_strip
num_leds: 30
color_correct: [80%, 60%, 100%]
id: rgb_led
name: "RGB LED Strip"
data_rate: 1MHz
Color Correction
----------------
It is often favourable to calibrate/correct the color produced by an LED strip light as the
perceived intensity of different colors will generally vary. This can be done by using
``color_correct`` to adjust the relative brightness of the RGB components.
Configuration variables:
------------------------
- **name** (**Required**, string): The name of the light.
- **num_leds** (*Optional*, int): The number of LEDs attached. The default is 1.
- **effects** (*Optional*, list): A list of :ref:`light effects <light-effects>` to use for this light.
- **id** (*Optional*, :ref:`config-id`): Manually specify the ID used for code generation.
- **data_rate** (*Optional*): Set the data rate of the SPI interface to the display. One of ``80MHz``, ``40MHz``, ``20MHz``, ``10MHz``, ``5MHz``, ``2MHz``, ``1MHz`` (default), ``200kHz``, ``75kHz`` or ``1kHz``.
- All other options from :ref:`Light <config-light>`.
You may also need to configure an ``output`` GPIO pin to control power to the LEDs, depending on your hardware. The
APA102 and friends do not have a ``CS`` input, and are write-only so the SPI ``miso`` pin should not be specified.
See Also
--------
.. figure:: images/rgb-detail.jpg
:align: center
:width: 75.0%
- :doc:`/components/light/index`
- :doc:`/components/output/ledc`
- :doc:`/components/output/esp8266_pwm`
- :doc:`/components/output/pca9685`
- :doc:`/components/output/tlc59208f`
- :doc:`/components/output/my9231`
- :doc:`/components/output/sm16716`
- :apiref:`rgb/rgb_light_output.h`
- :ghedit:`Edit`