MAX31855 K-Type Thermocouple Temperature Sensor =============================================== .. seo:: :description: Instructions for setting up MAX31855 Thermocouple temperature sensors. :image: max31855.jpg The ``max31855`` temperature sensor allows you to use your MAX31855 thermocouple temperature sensor (`datasheet `__) with ESPHome As the communication with the MAX31855 is done using SPI, you need to have an :ref:`SPI bus ` in your configuration with the **miso_pin** set (MOSI is not required). Connect ``GND`` to ``GND``, ``VCC`` to ``3.3V`` and the other three ``MISO`` (or ``SO`` for short), ``CS`` and ``CLOCK`` (or ``CLK``) to free GPIO pins. .. figure:: images/temperature.png :align: center :width: 80.0% .. code:: yaml # Example configuration entry spi: miso_pin: D0 clk_pin: D1 sensor: - platform: max31855 name: "Living Room Temperature" cs_pin: D2 update_interval: 60s Configuration variables: ------------------------ - **name** (**Required**, string): The name for the temperature sensor. - **cs_pin** (**Required**, :ref:`Pin Schema `): The Chip Select pin of the SPI interface. - **update_interval** (*Optional*, :ref:`config-time`): The interval to check the sensor. Defaults to ``60s``. - **reference_temperature** (*Optional*, :ref:`config-id`): Access the internal temperature sensor of the MAX31855. Requires a **name** and/or **id**. - **spi_id** (*Optional*, :ref:`config-id`): Manually specify the ID of the :ref:`SPI Component ` if you want to use multiple SPI buses. - **id** (*Optional*, :ref:`config-id`): Manually specify the ID used for code generation. - All other options from :ref:`Sensor `. See Also -------- - :ref:`sensor-filters` - :doc:`dallas` - :doc:`dht` - :doc:`adc` - :doc:`max6675` - :doc:`max31865` - `MAX31855 Library `__ by `Adafruit `__ - :apiref:`max31855/max31855.h` - :ghedit:`Edit`