MPU6050 Accelerometer/Gyroscope Sensor ====================================== .. seo:: :description: Instructions for setting up MPU6050 Accelerometer and Gyroscope sensors. :image: mpu6050.jpg The ``mpu6050`` sensor platform allows you to use your MPU6050 Accelerometer/Gyroscope (`datasheet `__, `SparkFun`_) sensors with ESPHome. The :ref:`I²C Bus ` is required to be set up in your configuration for this sensor to work. This component only does some basic filtering and no calibration. Due to the complexity of this sensor and the amount of possible configuration options, you should probably create a custom component by copying and modifying the existing code if you want a specific new feature. Supporting all possible use-cases would be quite hard. .. figure:: images/mpu6050-full.jpg :align: center :width: 50.0% MPU6050 Accelerometer/Gyroscope Sensor. .. _SparkFun: https://www.sparkfun.com/products/11028 .. figure:: images/mpu6050-ui.png :align: center :width: 80.0% .. code-block:: yaml # Example configuration entry sensor: - platform: mpu6050 address: 0x68 accel_x: name: "MPU6050 Accel X" accel_y: name: "MPU6050 Accel Y" accel_z: name: "MPU6050 Accel z" gyro_x: name: "MPU6050 Gyro X" gyro_y: name: "MPU6050 Gyro Y" gyro_z: name: "MPU6050 Gyro z" temperature: name: "MPU6050 Temperature" Configuration variables: ------------------------ - **address** (*Optional*, int): Manually specify the I²C address of the sensor. Defaults to ``0x68``. - **accel_x** (*Optional*): Use the X-Axis of the Accelerometer. All options from :ref:`Sensor `. - **accel_y** (*Optional*): Use the Y-Axis of the Accelerometer. All options from :ref:`Sensor `. - **accel_z** (*Optional*): Use the Z-Axis of the Accelerometer. All options from :ref:`Sensor `. - **gyro_x** (*Optional*): Use the X-Axis of the Gyroscope. All options from :ref:`Sensor `. - **gyro_y** (*Optional*): Use the Y-Axis of the Gyroscope. All options from :ref:`Sensor `. - **gyro_z** (*Optional*): Use the Z-Axis of the Gyroscope. All options from :ref:`Sensor `. - **temperature** (*Optional*): Use the internal temperature of the sensor. All options from :ref:`Sensor `. - **update_interval** (*Optional*, :ref:`config-time`): The interval to check the sensor. Defaults to ``60s``. - **id** (*Optional*, :ref:`config-id`): Manually specify the ID used for code generation. See Also -------- - :ref:`sensor-filters` - :doc:`template` - :doc:`ultrasonic` - :apiref:`mpu6050/mpu6050.h` - `i2cdevlib `__ by `Jeff Rowberg `__ - :ghedit:`Edit`