MCP3008 I/O Expander
====================

.. seo::
    :description: Instructions for setting up MCP3008 10 Bit Analog to Digital Converter in ESPHome.
    :keywords: MCP3008
    :image: images/mcp3008.jpg

The Microchip Technology Inc. MCP3008
devices are successive approximation 10-bit Analogto-Digital (A/D) converters with on-board sample and
hold circuitry.

.. figure:: images/mcp3008.jpg
    :align: center
    :width: 50.0%


.. _mcp3008-component:

Component/Hub
-------------

The MCP3008 component allows you to use MCP3008 8-Channel 10-Bit A/D Converter
(`datasheet <http://ww1.microchip.com/downloads/en/DeviceDoc/21295d.pdf>`__,
`Adafruit <https://www.adafruit.com/product/856>`__) in ESPHome.
It uses the :ref:`SPI Bus <spi>` for communication.

Once configured, you can use any of the 8 pins as
sensors for your projects.

Each pin will respond with a voltage calculated off of the reference_voltage (default is 3.3v).
It calculates the voltage by multplying the reference_voltage * value on the pin (basically the percentage of VREF)

Most configurations will set the reference_voltage = VREF (pin 13 on the chip)

If you want just the scaled value you can use the read_data function
  ``float MCP3008::read_data(uint8_t pin)``

.. code-block:: yaml

    # Example configuration entry
    mcp3008:
      cs_pin: D8

    # Example config of sensors.
    # This is a NTCB3950 10K thermocoupler attached to pin 0
    # of the MCP3008 with a 10K resistor as a voltage divider.
    # See `resistance` and `ntc` platorms for other options
    sensor:
      - platform: mcp3008             # Attached to pin 0 of the MCP3008.
        reference_voltage: 3.19
        update_interval: 1s
        id: freezer_temp_source
        number: 0                     # MCP3008 pin number
      - platform: resistance
        id: freezer_resistance_sensor
        sensor: freezer_temp_source
        configuration: DOWNSTREAM
        resistor: 10kOhm
      - platform: ntc
        id: freezer_temp
        sensor: freezer_resistance_sensor
        calibration:
          b_constant: 3950
          reference_temperature: 25°C
          reference_resistance: 10kOhm
        name: Freezer Temperature

Configuration variables:
- **id** (**Required**, :ref:`config-id`): The id to use for this MCP3008 component.
- **cs_pin** (**Required**, int): The SPI cable select pin to use


Sensor
------

The ``mcp3008`` sensor allows you to use your MCP3008 10-Bit A/D Converter sensors with ESPHome.
First, setup a :ref:`MCP3008 Hub <mcp3008-component>` for your MCP3008 sensor and then use this
sensor platform to create individual sensors that will report the voltage to Home Assistant.

Configuration variables:

- **id** (**Required**, :ref:`config-id`): The id of the parent MCP3008 component.
- **number** (**Required**, int): The pin number of the MCP3008
- **reference_voltage** (*Optional*, float): The reference voltage. Defaults to ``3.3V``.
- **update_interval** (*Optional*, :ref:`config-time`): The interval to check the sensor. Defaults to ``1s``.

See Also
--------

- :ref:`spi`
- :apiref:`mcp3008/mcp3008.h`
- :ghedit:`Edit`