esphome-docs/components/sensor/t6615.rst
2022-01-31 08:05:20 +01:00

75 lines
2.4 KiB
ReStructuredText

T6613/15 CO2 Sensors
==================================
.. seo::
:description: Instructions for setting up T6613 and T6615 sensors for ESPHome
:image: t6615.jpg
:keywords: t6613 t6615
The ``t6615`` sensor platform allows you to use T6613 and T6615 family sensors
(`amphenol`_) with ESPHome. T6613 sensors are unreferenced and require ABC to
calibrate daily, while the T6615 sensors have a sealed reference gas and
do not require ABC calibration. All ppm ranges are supported by this platform.
.. figure:: images/t6615.png
:align: center
:width: 50.0%
T6615 CO_2 Sensor.
.. _amphenol: https://amphenol-sensors.com/en/telaire/co2/525-co2-sensor-modules/319-t6615
As the communication is done using UART, you need to have an :ref:`UART bus <uart>` in your configuration with the
``rx_pin`` connected to the TX pin of the device (pin 10) and the ``tx_pin`` connected to the RX Pin of the device (pin
11). The baud rate should be set to 19200.
Additionally, the T6613/15 sensors require 5V power, while most ESP platforms only output 3.3V from their onboard
regulator, so you may need some additional components to power up the sensor.
.. code-block:: yaml
# Example configuration entry
uart:
rx_pin: 1
tx_pin: 3
baud_rate: 19200
sensor:
- platform: t6615
co2:
name: "CO2"
update_interval: 60s
Configuration variables:
------------------------
- **co2** (**Required**): The CO_2 data from the sensor in parts per million (ppm).
- **name** (**Required**, string): The name for the CO_2 sensor.
- **id** (*Optional*, :ref:`config-id`): Set the ID of this sensor for use in lambdas.
- All other options from :ref:`Sensor <config-sensor>`.
- **update_interval** (*Optional*, :ref:`config-time`): The interval to check the
sensor. Defaults to ``60s``.
- **uart_id** (*Optional*, :ref:`config-id`): Manually specify the ID of the :ref:`UART Component <uart>` if you want
to use multiple UART buses.
- **id** (*Optional*, :ref:`config-id`): Manually specify the ID used for actions.
.. figure:: images/t6615-pins.png
:align: center
:width: 80.0%
Pins on the T6615. Only the ones marked with a red circle need to be connected.
See Also
--------
- :ref:`sensor-filters`
- `UART Protocol Documentation <https://amphenol-sensors.com/en/component/edocman/561-telaire-co2-sensors-uart-communications-protocol/download?Itemid=8486%20%27>`__
- :apiref:`t6615/t6615.h`
- :ghedit:`Edit`