esphome-docs/cookbook/endstop-cover.rst
Otto Winter 6053f490b5
Update svg2png and seo.py (#1380)
Co-authored-by: Jesse Hills <3060199+jesserockz@users.noreply.github.com>
2021-11-16 15:19:33 +13:00

95 lines
2.6 KiB
ReStructuredText

Template Cover with Endstops
============================
.. seo::
:description: An example of how to integrate covers with endstops in ESPHome.
:image: window-open.svg
The following is an example configuration for controlling covers (like window blinds etc)
with ESPHome. This guide assumes that the cover is set up with two endstops at the top
and the bottom. When these endstops are reached, the cover will automatically stop.
To protect the motors from spinning indefinitely (in case an endstop fails) the motors
also have a maximum run time - after 3 minutes they will automatically turn off even if the
endstop is not reached.
ESPHome uses Home Assistant's cover architecture model which has two states: "OPEN" or
"CLOSED". We will map OPEN to "cover is at the top endstop" and CLOSE to "cover is at the bottom".
.. code-block:: yaml
switch:
# The switch that turns the UP direction on
- platform: gpio
pin: D1
id: up_pin
# Use interlocking to keep at most one of the two directions on
interlock: &interlock_group [up_pin, down_pin]
# If ESP reboots, do not attempt to restore switch state
restore_mode: always off
# The switch that turns the DOWN direction on
- platform: gpio
pin: D2
id: down_pin
interlock: *interlock_group
restore_mode: always off
binary_sensor:
- platform: gpio
pin: D4
id: top_endstop
- platform: gpio
pin: D5
id: bottom_endstop
cover:
- platform: endstop
name: "My Endstop Cover"
id: my_cover
open_action:
- switch.turn_on: up_pin
open_duration: 2min
open_endstop: top_endstop
close_action:
- switch.turn_on: down_pin
close_duration: 2min
close_endstop: bottom_endstop
stop_action:
- switch.turn_off: up_pin
- switch.turn_off: down_pin
max_duration: 3min
You can then optionally also add manual controls to the cover with three buttons:
open, close, and stop.
.. code-block:: yaml
binary_sensor:
# [...] - Previous binary sensors
- platform: gpio
id: open_button
pin: D3
on_press:
- cover.open: my_cover
- platform: gpio
id: close_button
pin: D6
on_press:
- cover.close: my_cover
- platform: gpio
id: stop_button
pin: D7
on_press:
- cover.stop: my_cover
See Also
--------
- :doc:`/guides/automations`
- :doc:`/components/cover/template`
- :doc:`dual-r2-cover`
- :ghedit:`Edit`